Flush cutting Blades

Needed when cutting flush against the surface

Flush cut blades enable you to cut concrete, limestone or sandstone flush against the surface.
This Premium range of blades are Korean quality (not Chinese like most of our competitors), so they feature optimum life and fast, clean dry-cutting.

Caution:
Flush cut diamond blades must be used with extreme care and caution.
They are for experienced trades people only.
Always check before use, or if extended operation:
● Blade is securely fastened to spindle.
● Blade guards are in place so cutting is safe
● The operator and operating environment is safe and compliant with all safety regulations and precautions
● Check countersunk screws are tight, and are not damaged or worn
● Blade flange is not worn or damaged
● Blade runs true, with no vibration
● Wear safety personal protection equipment as per regulations
If you have any doubts, or the blade is damaged in any way, do not use.

Note - If you are cutting dry, always be aware of the danger of breathing in the dust. Ensure a dust extraction system is used with a suitable filter fitted. Use a half face respirator or a PAPR (Powered air purifying respirator). Even if you are cutting wet, the slurry created can dry out and create a hazard for other users - dispose of slurry as per your local regulations.

PREMIUM Series Flush Cutting Blades

4"/100mm Diameter Depth of cut 32mm approx Turbo segment for fast cutting and cooling M14 threaded centre $75 incl GST ex stock Perth 5"/125mm Diameter Depth of cut 41mm approx Turbo segment for fast cutting and cooling M14 threaded centre $95 incl GST ex stock W.A. 7"/180mm Diameter Depth of cut 50mm approx Turbo segment for fast cutting and cooling M14 threaded centre $125 incl GST ex stock WA 9"/230mm Diameter Depth of cut 68mm approx Turbo segment for fast cutting and cooling M14 threaded centre $165 incl GST ex stock WA

We also stock:
16"/416mm x 2.8mm HSL-FC Flush Cut blade
To suit Tyrolit HBE400 and Guarda Flush cut saws.
For hard concrete, heavy steel and tilt panel.
1"/25.4mm  centre
6 x countersunk 8.25mm diameter holes, 30.3mm centre to blade centre.
1 x 11mm pin hole
(40 - 2.8m -122 x 7 x M243)
(Will not fit Eibenstock ETR400 without minor alterations to saw)
$330 Incl GST

Prices correct as of 1/3/22 but subject to change.

Please see our Contact Us page for Australia wide delivery information.

Disclaimer: the information on this website is provided in good faith and believed to be reliable and accurate at this time.
However, the information is provided on the basis that the reader will be solely responsible for assessing the information and its veracity and usefulness. UDT shall in no way be liable, in negligence or howsoever, for any loss sustained or incurred by anyone relying on the information, even if such information is or turns out to be wrong, incomplete, out-of-date or misleading.

Tornadao ehwa weha Sydney Melbourne Adelaide tools